This is a pre-stain, clear wood sealer that enables uniform stain application on soft woods, such as fir, pine, or hemlock. Using this product helps to avoid the appearance of uneven, blotchy staining.
*Old Masters Wood Conditioner is also available in a VOC compliant formula for the Ozone Transport Commission states and South Coast Air Quality Management District. This formula may be open for a longer amount of time before stain must be applied. See product instructions for more information.
Where to Use
Wood Conditioner is recommended for use on soft woods such as pine, fir, maple, or poplar. It can be applied under oil- or water-based stains, but stain must be applied over Wood Conditioner within two hours.
Ideal for use on soft woods which are being stained with or adjacent to hardwoods.
Surface Preparation
All surfaces must be clean, dry, and free from dirt, wax, or grease. If persistent wax exists, remove with fine steel wool saturated with paint thinner or alcohol. This product does not take the place of sanding sealer in its usage. It is a pre-stain treatment only.
Bare Wood: Sand the wood thoroughly with medium grit sandpaper and progress to fine grit sandpaper. Always sand in the direction of the wood grain. Sand smooth and remove all dust.
Previously Finished Surfaces: Strip the surface completely down to bare wood with paint or varnish remover, making sure all previous finishes are removed. Surface must be sanded smooth. Remove all dust.
Note: DO NOT use a tack rag to remove dust, as it may leave a residue that will interfere with adhesion.
Application
Stir product thoroughly with a circular, lifting motion to disperse contents evenly.
- Apply with a polyester or nylon brush. Ensure entire surface has been coated.
- Allow Wood Conditioner to penetrate surface for 5 to 15 minutes. Remove excess by wiping with a clean rag. Do not leave a surface film; work in a small area so the product cannot set up.
- Do not allow to dry thoroughly. Stain must be applied over Wood Conditioner within 2 hours.
Helpful Hints
Color depth may vary according to type of wood, stain, and application technique. To assure that your finished color is accurate, we highly recommend you test your technique, wood stain, and wood type before you start your project.
Thinning
Do not thin. Use as packaged.
Coverage
Approximately 400 to 500 square feet per gallon depending upon method of application and the type and porosity of wood.
Drying Time
Do not allow to dry thoroughly. Stain must be applied over Wood Conditioner within 2 hours.
Cleanup
Using a cleaning solvent, such as paint thinner or mineral spirits, is recommended for cleanup. The use of paint thinners or mineral spirits may violate VOC compliancy in your area. Check with your local government agencies to ensure proper compliancy.
